Computrainer skewer generator#

The load generator is connected to a hand unit which may be used to control the load generator directly, and it also is connected to a desktop computer, which offers more advanced opportunities for control. Now it fits the wind trainer fine, and the stresses are fed through axle and skewer clamping surfaces as they should. RacermateвЂ™s Computrainer is an electronic load generator that is fixed to a rear wheel bicycle training stand. The spring keeps it centred without damage, and it lines up beautifully. RacermateвЂ™s Computrainer is an electronic load generator that is fixed to a rear wheel bicycle training stand. I set it up and it works with Computrainer software, Zwift and perf-pro studeo. I have an older computrainer pro- the high end Lab quality model with power supply, din cable, stereo to usb wheel block and heart rate sensor. The LBS supplied a 3mm thick spacer that was 10mm inside, and 18mm outside, close enough to the diameter of the axle and outside diameter of the skewer clamp. 180 mm length Comes with spacers as well in different sizes. However, on the non-drive side, the clamp still fitted too deep into the socket, so the socket would contact the frame. I found a solution in a different QR with a taper that matched the sockets in the wind trainer. The could also damage the frame, or at least mar the paint.

However, I did not have the chance to do back-to-back testing with these two trainers, so I cannot claim that they feel exactly the same. My rear brakes were really tight and now they rubbed. BMC (Time Machine) Official BMC Time Machine Owners Thread New BMC Tri/TT bike photo Canyon Speedmax. The CompuTrainer, which is a very popular power trainer, costs 1000 (CompuTrainer Classic, base model with the Magnet Cadence Sensor). It is not square, so if the QR clamp or nut fit too deeply into the sockets of the wind trainer, said sockets will contact that ridge, and without a square face, will not make a secure connection. I adjusted it with the skewer and checked out the rotation.

Computrainer skewer software#

The problem is the ridge molded into the dropout above the axle slot. Rear wheel trainer skewer - Software You can use the handbar control to set the wattage on the load generator according to your workouts, or you can connect it to your Windows PC or Mac running the provided, Computrainer 3D, PerfPro Studio software.